How do you program a DirecTV Genie remote? Programming a DirecTV Genie remote is a straightforward process that allows you to control multiple DirecTV receivers from a single remote. This guide will walk you through the steps to program your DirecTV Genie remote, ensuring that you can enjoy seamless and convenient access to all your favorite channels and features.
Before you begin, make sure you have the following items ready:
- DirecTV Genie remote
- DirecTV receiver
- Power source for the DirecTV receiver
Step 1: Power on your DirecTV receiver. Make sure it is connected to the power source and turned on.
Step 2: Press and hold the “Select” button on your DirecTV Genie remote for about 5 seconds. You will see the “Device” button light up, indicating that the remote is in programming mode.
Step 3: Press the “Device” button on the remote to cycle through the available devices. Select the device you want to program by pressing the “Device” button until the correct device is highlighted.
Step 4: Press the “Select” button to confirm the device selection. The remote will now attempt to pair with the DirecTV receiver.
Step 5: If the pairing is successful, you will see a confirmation message on the DirecTV receiver’s screen. If not, repeat steps 2-4 until the pairing is successful.
Step 6: Once the pairing is complete, you can use your DirecTV Genie remote to control the selected device. Press the appropriate buttons on the remote to change channels, adjust volume, or access other features.
That’s it! You have successfully programmed your DirecTV Genie remote. Now you can enjoy the convenience of controlling multiple DirecTV receivers from a single remote. If you need to program additional devices, repeat the above steps for each device.
Remember, programming your DirecTV Genie remote may require occasional updates or reprogramming due to software updates or changes in your DirecTV service. In such cases, refer to the DirecTV user manual or contact DirecTV customer support for assistance.
