How to Program Garage Door Keypad Craftsman: A Step-by-Step Guide
Garage door keypad Craftsman is a popular choice for many homeowners due to its reliability and ease of use. Programming the keypad is a straightforward process that can be completed in a few simple steps. Whether you are installing a new keypad or replacing an old one, this guide will walk you through the process of programming your Craftsman garage door keypad.
Step 1: Gather the Necessary Tools and Materials
Before you begin programming your Craftsman garage door keypad, make sure you have the following items:
– Craftsman garage door keypad
– Programming tool (usually included with the keypad)
– Garage door remote control
– Garage door opener
Step 2: Locate the Programming Button
Most Craftsman garage door keypads have a programming button located on the back of the keypad. This button is typically labeled “Program” or “Learn.” Press and hold this button for a few seconds until the keypad’s indicator light begins to flash.
Step 3: Enter the Programming Code
With the programming button still pressed, locate the programming code on the back of your garage door opener. This code is usually a series of numbers and can be found in the owner’s manual or on a sticker attached to the opener. Enter the code using the keypad’s number buttons.
Step 4: Program the Keypad
After entering the programming code, release the programming button. The keypad’s indicator light should stop flashing and remain on. This indicates that the keypad has been successfully programmed. If the light goes off, repeat steps 3 and 4 until the keypad is programmed.
Step 5: Test the Keypad
To ensure that the keypad is working correctly, press the button you just programmed. The garage door should open or close, depending on your settings. If the door does not respond, double-check the programming code and try again.
Step 6: Re-Program Additional Keypads (if necessary)
If you have multiple keypads, you will need to repeat the programming process for each additional keypad. Simply follow steps 1 through 5 for each keypad.
Conclusion
Programming your Craftsman garage door keypad is a simple and straightforward process that can be completed in just a few minutes. By following this step-by-step guide, you can ensure that your keypad is working correctly and securely. If you encounter any issues during the programming process, consult your owner’s manual or contact Craftsman customer support for further assistance.
